Mamba S Clip-In Pedals

Installing all the pins is not necessary. You may find that cleats engage more easily with fewer or even no pins. We encourage you to experiment with various pin configurations to find the setup that best suits your riding needs.

The Mamba S pedals are equipped with a single bushing on the inner side and a 686 cartridge bearing (6mm x 13mm x 5mm) on the outer side.

There isn't a fixed schedule for regreasing through the GRS port. We recommend adding grease whenever you notice increased resistance during pedal operation. Please keep in mind that using the GRS port for regreasing is intended as a temporary solution. For optimal performance and longevity of your pedals, we advise a full service every six months.

Light bicycle greases from Finishline, Muc-off, or Parktools are suitable. Apply the grease using a syringe for best results.

To keep your pedals in top shape, we provide Clip mechanism replacement kit, Axle Replacement Kits and Pedal Pin Kits as available spare parts.

For guidance on both removing and replacing the axles, please refer to our service manual. The necessary special tools for this procedure are included in our axle replacement kit.

Same clip, same GRS grease port, same 18 degree release — the difference is footprint. The Mamba's platform is 101 x 102mm and suits bigger feet and rougher, downhill-flavoured riding, at 450g single or 500g double. The Mamba S trims that to 83 x 98mm and 405g or 465g — the better fit for trail and gravel riding, or smaller feet. If you are between the two, pick by shoe size: the platform should end near the edges of your forefoot.